RE: Air Hogs Reflex Heli Help Page
I would try ebay.... There are folks selling tail rotor props that look like they might fit. You might try asking the seller if he knows if they fit Reflex or not. For example: http://cgi.ebay.com/5-TAIL-ROTOR-BLADE-for-silverlit-picooz-picco-z-rc-heli_W0QQitemZ260424212949QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?hash=item3ca27e21d5&_trksid=p3911.c0.m14&_trkparms=65%3A12|66%3A2|39%3A1|72%3A1205|240%3A1318|301%3A1|293%3A1|294%3A50 This is that seller's store: http://shop.ebay.com/merchant/h5bjt_W0QQ_nkwZQQ_armrsZ1QQ_fromZ Also, if too wide, I have read that some people trim the rings on the heli to fit larger props. Poke around on ebay though, you might find the exact prop.
Posted on: 6/10/2009 3:44 PM by Author "ackatak" in the forum "Electric Indoor & Micro RC Flight"
http://www.rcuniverse.com/forum/fb.asp?m=8841621

RE: Air Hogs Reflex Heli Help Page
Ok, got it.... based on another person's post, I tightened the top trim knob as far as I could to the right, then flew the heli for a couple seconds, then loosened up and got the normal trim range back. So I can trim for left spin or right spin now. Whew... I'm flying again... Thanks everyone. (Original problem was could not correct for spin to the right no matter how far left the trim knob was turned.)
Posted on: 5/3/2009 4:05 PM by Author "ackatak" in the forum "Electric Indoor & Micro RC Flight"
http://www.rcuniverse.com/forum/fb.asp?m=8737053

RE: Air Hogs Reflex Heli Help Page
Ahhh... I ended up replacing the upper stabilizer too (got the upper-lower combo kit) and that seemed to help some. I guess they need to be somewhat matched. A little weight in front made it more stable, but still some untrimmable spin, but hover is good. I am thinking it is a blade balance issue, so I'll try that next.
Posted on: 5/1/2009 11:34 AM by Author "ackatak" in the forum "Electric Indoor & Micro RC Flight"
http://www.rcuniverse.com/forum/fb.asp?m=8731676

RE: Air Hogs Reflex Heli Help Page
I've had my Reflex for a few months now, and managed to break the lower stabilizer. I ordered one from waynenik on ebay and received it. Replaced it with no problem (thanks, Wayne for the excellent instructions!). Now I can't trim the Reflex properly... it always spins to the right (clockwise) and even backing off the trim knob all the way counter-clockwise does not stop the rotation. I have a full charge on the batteries and have tried swapping the blades with spares, but the body always spins to the right making the heli unflyable. Any ideas? Thanks in advance! (I'm thinking I need to replace the upper stabilizer also (to match?), but I can't manage to remove the pin that holds it on to the shaft.)
Posted on: 4/29/2009 6:57 PM by Author "ackatak" in the forum "Electric Indoor & Micro RC Flight"
http://www.rcuniverse.com/forum/fb.asp?m=8726861