|
RE: New Evolution 10cc gas engine
at ~14500 RPMs. Dave [/quote] 12x6=13500? BCCHI
Posted on: 5/20/2013 7:27 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11517742
RE: Choice between DLE20 and Mintor 22, What would you pick out?
you can beat it. The price will probably go up. BCCHI
Posted on: 5/15/2013 6:28 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11512667
RE: Slow transition on DLE20
light on it is vary easy to see why this is a problem with the #4 ignition. BCCHI Grumpy #2.AMA 2500
Posted on: 9/11/2012 8:20 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11225695
RE: Ignition Module failure
[quote]ORIGINAL: Lifer Thanks for the replies, but I still have the same question: How can it produce a spark but not allow the engine to fire? I replaced the old unit with a new one and it fired right up. Again, does anyone know how the old one can spark, but not support the engine to run? [/quote] They just told you in the last two posts.Read again. BCCHI
Posted on: 9/10/2012 8:20 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11224530
RE: Saito FG57 Fourstroke
the spark plug. Do not ground the red wire this will let the smoke out.Then it will not work. BCCHI
Posted on: 9/10/2012 7:45 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11224483
RE: 100 cc Sachs-Dolmar needs ignition module
not C&H Ignitions. BCCHI
Posted on: 9/10/2012 7:29 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11224467
RE: A&M question
[quote]ORIGINAL: KenLambert What A&M engine has a 39mm bore? it would be smaller than the 2.4., definatly before my time [/quote] A&M built a few 2.0,looked about like the 2.4. BCCHI
Posted on: 9/10/2012 7:03 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11224448
RE: Throttle servo buzzing for DLE20
has nothing to do with your problem. BCCHI
Posted on: 8/27/2012 11:00 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11208601
RE: DLE Engines?
I have eight DLE engines ,all of them have been great.I usually install Bowman rings in them before I even run them.DLE did make a big improvement in there piston rings a couple years ago. They are probably fine now. BCCHI
Posted on: 8/27/2012 10:54 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11208598
RE: RCIGNITION.COM
[quote]ORIGINAL: Nosedragger He retired 2 years ago. [/quote] HE's hideing under his rock in AZ,only comes out when full moon o Friday the 13 th, BCCHI
Posted on: 8/26/2012 8:29 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11207116
RE: DLE-20 Ignition Module Bad ???
you have voltage going into the ign. Check the Futaba type plugs for bent pins. BCCHI
Posted on: 8/18/2012 10:15 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11198357
RE: Hangar 9 Katana 50. Which engine?
wheels. BCCHI
Posted on: 8/12/2012 6:18 PM by Author "bcchi"
in the forum "3D Flying!"
http://www.rcuniverse.com/forum/fb.asp?m=11190913
RE: 26 gas16/8 or 17/10 prop
flying plane. thanks Jeff [/quote] Wait till you turn 77 and see how it is. LOL BCCHI (AMA 2500).
Posted on: 8/11/2012 8:25 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11189924
RE: SV 50cc
Agree, BCCHI
Posted on: 8/11/2012 8:21 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11189920
RE: RCG 20cc question...
you took off. BCCHI
Posted on: 8/11/2012 8:18 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11189916
RE: SV 50cc
use the TLAR method.But I have timed a couple of engines in the past. BCCHI
Posted on: 8/9/2012 10:04 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11187807
RE: G20 sensor.
[quote]ORIGINAL: gr8flyer55 Is this the connector out of the ignition on a G20? John [/quote] Yes,BCCHI
Posted on: 8/8/2012 9:25 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11186470
RE: G20 sensor.
[quote]ORIGINAL: gr8flyer55 Do they use the same wire color coding? White, red, black so you can figure out the interconnections? [/quote] Connector is JST,Color code is standard. I have JST parts.Send me a SASE and I will send you a few. BCCHI
Posted on: 8/7/2012 7:40 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11184992
RE: RCG 20cc question...
I do not no if your ignitions is all set the way the pictures show? But your spark plug cap is not all the way down on the CM 6 spark plug.When the cap is on all the way It should cover the hex of the spark plug.Push hard with the heel of your hand,They go on hard and come off harder. Good Luck BCCHI
Posted on: 7/20/2012 10:28 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11163217
RE: Bob Dunhams first radio
] No Bob Dunham passed away some time ago. BCCHI AMA 2500
Posted on: 7/19/2012 10:10 PM by Author "bcchi"
in the forum "Golden Age, Vintage & Antique RC"
http://www.rcuniverse.com/forum/fb.asp?m=11162055
RE: Lee custom gas engine
where I could obtain one of those? [/quote] Phone 240-888-5902.Ask for Adrian. BCCHI
Posted on: 7/9/2012 9:48 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11149546
RE: DLE Spark plug, wire & cap
[quote]ORIGINAL: grossy2 Can anybody tell me the spec's of the resistor that's in the cap for a CM-6 plug? Cheers [/quote] I-K 1 W BCCHI
Posted on: 7/8/2012 11:16 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11148305
RE: HT lead splice
That easy,how many do you want.I will send you one to test. I no a guy that caan build them if you can get him to go to work.He wants to go flying all the time.Besides that he is old and crabby. BCCHI
Posted on: 6/29/2012 11:17 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11137336
RE: ZENOAH G26 BACKFIRING
would draw 2.1/2 to three AMPS. BCCHI
Posted on: 6/26/2012 8:39 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11133295
RE: New RCXEL 7.4V
] Bingo BCCHI
Posted on: 6/22/2012 11:31 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11128513
RE: DLE 55 won't run
O,boy. Open both carb needles 1/2 turn and try again. BCCHI
Posted on: 6/13/2012 10:33 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11117606
RE: DLE 20 - Can the carb be rotated 180 deg
Protect the braid on the spark plug lead where it is touching on th cowl. A fibre glass cowl can cut through the plug lead in one flight. BCCHI
Posted on: 6/11/2012 10:44 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11115206
RE: DL 50 won't start!
;s like the guy who could not find top dead center because his engine was mounted inverted,LOL BCCHI
Posted on: 6/11/2012 10:39 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11115202
RE: New RCXEL 7.4V
If you have a RFI problem with rcexl ignition system you probably do not have the plug cap all the way down over the hex of the spark plug.We had very few cpmplaints fo RFI with the RCEXL ignitions and nearly all of them were because the spark plug cap was not all the way on. If you do not use the RCEXL ignition which one are you going to use. BCCHI
Posted on: 6/11/2012 10:20 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11115188
RE: New RCXEL 7.4V
I would bet you are wrong.I have seen the new circuit that XU Liang is useing.Not a voltage reg. Adrian will not be useing the new RCEXL circuit on the C&H Ignitions,but he can build the new Ignitions to work from 3.7 to 12 volts. BCCHI
Posted on: 6/10/2012 8:50 PM by Author "bcchi"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=11113936
| 
