RE: MOKI RADIAL Care and Maintenence
Thanks serial 693 I think that's what happened. To time motor once I have parts do you know if the timing mark goes at 1200 o'clock in line with #1 at top dead center?
Posted on: 6/27/2012 6:33 AM by Author "crusier" in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=11133625

RE: MOKI RADIAL Care and Maintenence
Ok Guys, I have a moki 215 6-7 years old bought from RCS. only finish the plane last year . I have 80 minutes of run time. Friday I was flying, great first fligh. Second flight not so great. Grinding noise throttled back engine quit. Went to turn it over by hand one place felt grinding. Removed front cover found brass gears. Three of the teeth stripped off dont know why. Engine came out of time valve damage and lifting rods damage on two cylinders. have not taken it apart any futher. First does anyone have a parts list, best place to buy parts? Anyone know how to time this motor. There is a timing mark on the steel primary gear what do you line this up with. Any info helpful thanks Bill
Posted on: 6/24/2012 4:59 PM by Author "crusier" in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=11130239

RE: YS CLUB
thanks for the reply. Is this something you could fix if I sent the engine?, also check internal parts and seals. Could you also test run and make sure I have a good idle. thanks Bill, I would rather start here then take It apart myself
Posted on: 11/9/2008 7:56 PM by Author "crusier" in the forum "3D Flying!"
http://www.rcuniverse.com/forum/fb.asp?m=8131207

RE: YS CLUB
I have a YS110dz ,bought it used, looks slightly used. Engine runs great full out, can't get it to idle well. Its take a long time from full motor for the engine to reach a safe idle speed then goes dead stick. Started with the regulator even with the top of the barrel, 1 1/2 turns out on the high end needle. 3 turns out from closed on low end. Ran three tanks through it still wont idle well not slow enough to land safely. Messed with settings until frustrated.Lots of smoke good transition from mid to high just cant get the thing to idle. Words or wisdom needed. Using YS 20 20 fuel. Os four stroke plug. Also in the event I'm not doing something wrong, and it is the motor, need to know where to send it for service and set-up, need someone who can adjust the thing.
Posted on: 11/7/2008 9:50 PM by Author "crusier" in the forum "3D Flying!"
http://www.rcuniverse.com/forum/fb.asp?m=8125463