Warm ESC
Recently upgraded my raptor to brushless......original esc fried.....now have both 30 and 40 amp units...however both get warm when running with the brushless setup....is this normal?
Posted on: 3/4/2009 1:53 PM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8543382

RE: Help !!!
Andy, Sent you an e-mail....please check it and let me know thanks Jim
Posted on: 2/11/2009 7:50 PM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8466503

RE: Help !!!
Andy, I changed the crystal 180 as you suggested, no difference I am highly suspisious the transmitter is the problem. I have a new one arriving today, and will let you know but am very disappointed that things should malfunction like this. Jim
Posted on: 2/11/2009 1:43 PM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8465279

Help !!! my Exceed G2 went psycho
I am noob to 6 channel. I have an exceed g2 and have been very slowly trying to get it set up and do the basics. Have been doing hops etc. no hover yet. but this morning I turned everything on and the copter started acting crazy like another tx was giving it inputs. Would not respond to my tx until near half throttle then would try to launch shut down tthrottle and control surfaces would cycle without any input from me. Whats going on? Has my tx or rx died? Any help is appreciated, all batteries were fully charged. Thanks in advance Jim
Posted on: 2/8/2009 5:34 PM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8450025

RE: Help !!!
I was wrong.....put all original equipment back on and heli still acted totally psychotic...flying surfaces would actuate and moter would attempt to spin up without any input from me on tx........what has let loose? no crashes......never even hovered yet.......Help !!!
Posted on: 2/8/2009 5:26 PM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8453621

RE: Help !!!
Well I just switched out the brushless gear for the original brushed setup.....and heli works like it's supposed to....so appears to be the battery or the ESC......Where are you X-heli man....I bought this as the upgrade kit from x-heli and it has only run 4-5 times. Jim
Posted on: 2/8/2009 1:12 AM by Author "jsamuels496" in the forum "Exceed RC Support - Helicopter"
http://www.rcuniverse.com/forum/fb.asp?m=8451311