|
RE: SD-10G Issue With TX Battery Voltage
I had the same problem after RF upgrade. Removed pack & tested with a load on it & battery made a big drop. It had a bad cell. Replaced with a 2000mah Eneloop NMH & it's ROCK STEADY.
Posted on: 12/16/2011 1:58 PM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10862747
RE: JR 8103 FLAP PROGRAMMING
Top Flite 60 SIZE P-47 Jr rx 649 one aileron servo throttle servo two flap servos on flap & aux 2 channels one rudder servo one elevator servo Would like to be controlled by three way switch flaps up, half way & full.
Posted on: 8/15/2011 8:55 AM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=10671369
JR 8103 FLAP PROGRAMMING
Can anyone help with step by step instructions for programming a JR 8103 for flaps using two servos PLEASE? I have spent all day trying to figure this out & it's driving me CRAZY.
Posted on: 8/15/2011 4:46 AM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=10671338
RE: Amy Winehouse Found Dead
Guys, THis is a RADIO CONTROL MODEL WEBSITE! Take it to FACEBOOK or some other website!
Posted on: 7/24/2011 2:26 PM by Author "roylab"
in the forum "Off Topic Forum - Cars, Trucks, Buggies and more"
http://www.rcuniverse.com/forum/fb.asp?m=10636697
RE: SD10-G DISPLAY
So then I should not be concerned @ this time. Thanks Mike!
Posted on: 5/23/2011 2:38 PM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10536655
RE: SD10-G DISPLAY
I am not leaving it in the sun. This happens during pre-flight checkout & flying time of 10 -15 minutes. I then place TX out of direct sunlight.
Posted on: 5/23/2011 10:08 AM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10536144
SD10-G DISPLAY
I noticed that the screen on my SD10-G Tx when in direct sunlight starts to darken @ each corner. Is this normal? It clears up when it is out of sunlight. Is this impending screen failure?
Posted on: 5/23/2011 9:47 AM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10536109
RE: SD10G BATTERY
Mike, What about the voltage fluctuation. I followed your instructions & these are the results. Charged battery with supplied wall wart. Turned on TX & got a reading of 8.1 - 7.9. After 20 minutes "on" the reading was 7.7 - 7.5 . Roy
Posted on: 2/24/2011 2:41 PM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10361110
RE: SD10G BATTERY
Hi Mike, I followed your instructions & these are the results. Charged battery with supplied wall wart. Turned on TX & got a reading of 8.1 - 7.9. After 20 minutes "on" the reading was 7.7 - 7.5 . Also, can a PEEK ELECTRONICS charger be used through the TX port? I have not done this, just inquiring? Thanks, Roy
Posted on: 2/24/2011 6:43 AM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10360059
SD10G BATTERY
Just got back my TX that was in for the RF modification. I charged the battery overnight using the Airtronics wall wart. After charge was complete I turned it on to check voltage & got a reading of 8.1 Volts. I noticed that the reading began fluctuating from 8.1v & 7.9v continuosly. Is this an indication of battery failure? Prior to sending the TX I never saw this fluctuation.
Posted on: 2/17/2011 3:40 PM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10343862
NEW 8 CHANNEL FHSS-3 RX
Just purchased (4) #92824 rx's FHSS-1 recently. Can these be converted to FHSS-3 technology in the future?
Posted on: 10/4/2010 1:29 PM by Author "roylab"
in the forum "Airtronics Support Forum"
http://www.rcuniverse.com/forum/fb.asp?m=10046755
RE: Pacific Aeromodel Clipped Wing Monocoupe Build
Thanks for the info. How much for complete airframe?
Posted on: 9/29/2010 8:04 PM by Author "roylab"
in the forum "ARF or RTF"
http://www.rcuniverse.com/forum/fb.asp?m=10036504
RE: Pacific Aeromodel Clipped Wing Monocoupe Build
Can someone tell me how long a wing panel & aileron on the the Coupe. I have an extra set of wings for my KANGKE MONOCOUPE & would like to clip them.
Posted on: 9/29/2010 9:07 AM by Author "roylab"
in the forum "ARF or RTF"
http://www.rcuniverse.com/forum/fb.asp?m=10035111
RE: ID Kit ¼ Super Decathlon, need advice + rebuild start
Anyone out there have the pattern for the windshield?
Posted on: 6/7/2010 12:44 PM by Author "roylab"
in the forum "Kit Building"
http://www.rcuniverse.com/forum/fb.asp?m=9787298
RE: RCS 140 ENGINE PROP NUT
Found one from Truturn 8mm x 1.25 thread for crank w/10mm od to fit into prop id w/10-32 thread other end for spinner. RCS 140 has a short shaft like MOKI 1.2.
Posted on: 12/21/2008 2:10 PM by Author "roylab"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=8267848
RE: RCS 140 ENGINE PROP NUT
RCS doesn't have any. Engine no longer handled by them.
Posted on: 12/20/2008 10:24 PM by Author "roylab"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=8266189
RCS 140 ENGINE PROP NUT
Anyone out there have an extra factory prop nut for a RCS 140 engine?
Posted on: 12/18/2008 2:43 PM by Author "roylab"
in the forum "Gas Engines"
http://www.rcuniverse.com/forum/fb.asp?m=8258573
RE: H9 Taylor Craft ?
Struts are req'd! I will email you a pdf file for the manual.
Posted on: 10/5/2008 8:59 PM by Author "roylab"
in the forum "ARF or RTF"
http://www.rcuniverse.com/forum/fb.asp?m=8022058
WORLD MODEL P-47 POWER
What do guys think of the Zeoah G-20 for this warbird or any others.
Posted on: 3/16/2008 4:52 PM by Author "roylab"
in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=7234574
RE: Dyna Flight Decathlon
Flying my Super Decathlon with a RCS 140 swinging a 16-8 Zinger prop. Power is adequate for scale flying. Plane weighs 16 lbs dry.
Posted on: 9/14/2006 8:30 AM by Author "roylab"
in the forum "Kit Building"
http://www.rcuniverse.com/forum/fb.asp?m=4746860
TOP FLITE GOLD EDITION P-47 PLANS WANTED
ANYONE OUT THERE HAVE A SET OF PLANS FOR THE TOP FLITE GOLD EDITION P-47 #TOPA0135 THAT THEY NO LONGER NEED?
Posted on: 6/9/2006 9:28 AM by Author "roylab"
in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=4371071
8103 TX
Danny, I have a 8103 TX. How do I program it when I have two aileron servos & two flap servos?
Posted on: 5/16/2006 9:49 AM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=4283776
RE: New 81" P-47 ARF coming from Hangar 9
Has anyone replaced the retracts with an air set-up yet? If so please provide all details, photo's etc.
Posted on: 4/26/2006 12:15 PM by Author "roylab"
in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=4208791
RE: Vinyl Clad Transmitter Case
TRY MARV JENSEN : http://www.jensenjetmodels.com/index.htm
Posted on: 3/14/2006 10:14 AM by Author "roylab"
in the forum "RC Radios, Transmitters, Receivers, Servos, gyros"
http://www.rcuniverse.com/forum/fb.asp?m=4032622
JR SERVO'S
Just picked up the following NIB servos: NES-4131 NES-3021 NES-3321 Can you tell me the specs for these? Tourque? Metal or plastic gears? Thanx
Posted on: 3/12/2006 7:53 PM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=4025807
RE: 8103 PROGRAMMING
Thanx for the quick response.
Posted on: 2/6/2006 3:41 PM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=3876369
8103 PROGRAMMING
How do you program an 8103 TX W/649 RX to use two aileron servo's.
Posted on: 2/6/2006 1:43 PM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=3875890
JR MAX 6 TRANSMITTER BATTERY CYCLING
Just aquired a JR MAX 6 transmitter. I installed new nicads in it. Charged the battery with my Einstein charger. Turned on the TX to see the voltage reading which read 11.3 volts. Then I started to discharge the battery but after a few minutes it shut down. Tried another Einstein unit, same thing. Is there a diode in the TX that prevents it from being discharged? I have two other newer JR TX'S that I use with the same Einstein charger with no problems. Please advise!
Posted on: 8/22/2005 10:11 PM by Author "roylab"
in the forum "JR Radio & Spektrum Radios"
http://www.rcuniverse.com/forum/fb.asp?m=3289159
FUEL TANK SIZE FOR SAITO 150
WHAT SIZE FUEL TANK SHOULD BE USED WITH A SAITO 150. ENGINE IS INSTALLED IN A TOP FLITE T-34 MENTOR.
Posted on: 6/7/2005 8:44 PM by Author "roylab"
in the forum "Glow Engines"
http://www.rcuniverse.com/forum/fb.asp?m=3052157
TOP FLITE T-34 MENTOR
LOOKING FOR ACTUAL FLYING WEIGHT, ENGINE SIZE & FLYING CHARACTERISTICS FOR A T-34 MENTOR W/FLAPS & RETRACTS.
Posted on: 5/19/2005 3:05 PM by Author "roylab"
in the forum "RC Warbirds and Warplanes"
http://www.rcuniverse.com/forum/fb.asp?m=2990935
| 
